Control chart. A laboratory monitoring perchlorate (CIO-4)in urine measured quality control samples made from synthetic urine spiked withCIO-4. The graph in Box5-2shows consecutive quality control measurements. Are any troubleshooting conditions from Box 5-2 observed in these data?

Short Answer

Expert verified

The troubleshooting conditions for a control chart which is monitoring perchlorate (CIO-4)in urine measured quality control samples made from synthetic urine spiked with(CIO-4)was explained.

Step by step solution

01

Definition of control chart

A Control Chart is a visual representation of the confidence intervals for a Gaussian distribution.

Interpretation:

It is necessary to explain the troubleshooting conditions for a control chart that monitors perchlorate(CIO-4)in urine measured quality control samples made from synthetic urine spiked with.

02

Signs of a process that might be out of control

Six signs that a process might be getting out of control.

1. Keen observation outside the action lines -No

2. There is always 2 out of 3 measurements between action and warning lines-No

3. There are all 7 consecutive measurements above or below the center line-Yes

4. There are all 6 measurements which can be increasing or decreasing where they are located-No

5. There are 14 points which are alternating up and down regardless where they are located-No

6. A nonrandom pattern-No

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

Standard addition. An unknown sample of Ni2+gave a current of 2.36μAin an electrochemical analysis. When 0.500mLof solution containing role="math" localid="1654761474124" 0.0187MNi2+was added to 25.0mLof unknown, the current increased to 3.79μA.

(a) Denoting the initial, unknown concentration as [Ni2+], write an expression for the final concentration, [Ni2+]f, after role="math" 25.0mLof unknown were mixed with 0.500mLof standard. Use the dilution factor for this calculation.

(b) In a similar manner, write the final concentration of added standard Ni2+, designated as [S]f.

(c) Find[Ni2+]in the unknown.

Spike recovery and detection limit. Species of arsenic found in drinking water include AaO33-(arsenite), AaO33-(arsenate),role="math" localid="1655008942536" (CH3)2Aso2(dimethylarsinate), and (CH3)AsO32-(methylarsonate). Pure water containing no arsenic was spiked with 0.40μgarsenate/L. Seven replicate determinations gave 0.39,0.40,0.38, 0.41,0.36,0.35, and 0.39μg/L15Find the mean percent recovery of the spike and the concentration detection limit (μG/L).

Standard addition graph. Allicin is a ~0.4wt%component in garlic with antimicrobial and possibly anticancer and antioxidant activity. It is unstable and therefore difficult to measure. An assay was developed in which the stable precursor alliin is added to freshly crushed garlic and converted to allicin by the enzyme alliinase found in garlic. Components of the garlic are extracted and measured by chromatography. The chromatogram shows standard additions reported as mg alliin added per gram of garlic. The chromatographic peak is allicin from the conversion of alliin.

(a)The standard addition procedure has a constant total volume. Measure the responses in the figure and prepare a graph to find how much alliin equivalent was in the unspiked garlic. The units of your answer will be mg alliin/g garlic. Find the 95%confidence interval, as well.

(b) Given that2molof alliin are converted to1molof allicin, find the allicin content of garlic (mg allicin/g garlic) including the95%confidence interval.

Here is a use objective for a chemical analysis to be performed at a drinking water purification plant: "Data and results collected quarterly shall will be used to determine whether the concentrations of haloacetates in the treated water demonstrate compliance with the levels set by the Stage 1 Disinfection By-products Rule using Method 552.2"(a specification that sets precision, accuracy, and other requirements).

Which one of the following questions best summarizes the meaning of the use objective?

(i) Are haloacetate concentrations known within specified precision and accuracy?

(ii) Are thehaloacetates detectable in the water?

(iii) Dothehaloacetate concentrations exceed the regulatory limit?

Distinguish raw data, treated data, and results.

See all solutions

Recommended explanations on Chemistry Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free