Suppose you have a liquid (say, water) in equilibrium with its gas phase, inside some closed container. You then pump in an inert gas (say, air), thus raising the pressure exerted on the liquid. What happens?

(a) For the liquid to remain in diffusive equilibrium with its gas phase, the chemical potentials of each must change by the same amount: dμl=dμg Use this fact and equation 5.40 to derive a differential equation for the equilibrium vapour pressure, Pv as a function of the total pressure P. (Treat the gases as ideal, and assume that none of the inert gas dissolves in the liquid.)

(b) Solve the differential equation to obtain

Pv(P)-PvPv=eP-PvV/NkT

where the ratio V/N in the exponent is that of the liquid. (The term Pv(Pv) is just the vapour pressure in the absence of the inert gas.) Thus, the presence of the inert gas leads to a slight increase in the vapour pressure: It causes more of the liquid to evaporate.

(c) Calculate the percent increase in vapour pressure when air at atmospheric pressure is added to a system of water and water vapour in equilibrium at 25°C. Argue more generally that the increase in vapour pressure due to the presence of an inert gas will be negligible except under extreme conditions.

Short Answer

Expert verified

The vapour pressure is 0.07 percent higher than it would be in the absence of air.

Step by step solution

01

Part (a) Step 1: Explanation

Using the equation 5.40, the chemical potential for the gas is as follows.

μg=μ°+kTlnPv

Where

μ°is constant

k is Boltzmann's constant

T is temperature

P is the partial pressure

Differentiating the equation with respect to P

ddPμg=ddPμ°+kTlnPv=0+kT1PvdPvdPdμgdP=kTPvdPvdP

The chemical potential for liquid is

μ1=GN

Where G is Gibbs free energy

Differentiating the equation with respect to pressure P

ddPμl=ddPGNdμldP=1NdGdP

The volume V is equal to the differentiation of the Gibbs free energy with respect to pressure.

dGdP=V

Substitute V for dGdP

dμldP=1N(V)=VN

02

Calculations

The change in chemical potentials for the two phases, liquid and gas, must be equal in equilibrium.

dμl=dμgdμldP=dμgdPSubstitute values ofdμ1dPanddμgdP.VN=kTPvdPvdPdPvdP=VNkTPv

Hence, the differential equation isVNkTPv

03

Part (b) Step 3: Explanation

The solution for the differential equationdPvdP=VNkTPvis in exponential form.Pv(P)=(constant)ePVNRT.(1)SubstitutePvforPPvPv=(constant)ePvVNkT(2)Dividetheequation(1)withtheequation(2),Pv(P)PvPv=(constant)ePVNkT(constant)ePVNkTPv(P)=PvPvePVNkTPkT=PvPveP-PvVNkT

As a result, the differential equation solution found in part (a) isPvPveP-PvNkT

04

Part (c) Step 4: Explanation

The vapour pressure of water at a temperature of 25°C is as follows.

P=0.03bar

As a result, when the total pressure is 1 bar, the vapour pressure is minimal.

P=1barP=1bar1.013×105N/m21barP=1.013×105N/m2

role="math" localid="1646939469352" Calculate the exponential value of the equationPvPveP-PvVNkT.eP-P2VNkT=ePVNkT

The value of Nk is equal to the gas constant for one mole of N, and the volume is

V=18×10-6m3

Therefore,

ePVNRT=ePVRT

Substituting the values

=exp1.013×105N/m218×10-6m3(8.31J/K)((25+273)K)=1.00074

05

Conclusion

According to the above calculation, the vapour pressure is 0.07 percent higher than it would be in the absence of air.

Because the volume of the liquid is substantially smaller than that of the gas, the quantityPVNkT is always less than 1.

At the critical moment, the ratio is comparable to one.

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

In a hydrogen fuel cell, the steps of the chemical reaction are
at-electrode:H2+2OH-2H2O+2e-at+electrode:12O2+H2O+2e-2OH-

Calculate the voltage of the cell. What is the minimum voltage required for electrolysis of water? Explain briefly.

In the previous section I derived the formula (F/V)T=-P. Explain why this formula makes intuitive sense, by discussing graphs of F vs. V with different slopes.

What happens when you add salt to the ice bath in an ice cream maker? How is it possible for the temperature to spontaneously drop below 0"C? Explain in as much detail as you can.

In constructing the phase diagram from the free energy graphs in Figure 5.30, I assumed that both the liquid and the gas are ideal mixtures. Suppose instead that the liquid has a substantial positive mixing energy, so that its free energy curve, while still concave-up, is much flatter. In this case a portion of the curve may still lie above the gas's free energy curve at TA. Draw a qualitatively accurate phase diagram for such a system, showing how you obtained the phase diagram from the free energy graphs. Show that there is a particular composition at which this gas mixture will condense with no change in composition. This special composition is called an azeotrope.

The standard enthalpy change upon dissolving one mole of oxygen at 25°C is -11.7 kJ. Use this number and the van't Hoff equation (Problem 5.85) to calculate the equilibrium (Henry's law) constant for oxygen in water at 0°C and at 100° C. Discuss the results briefly.

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free