Figure shows a resistor of resistance R= 6.00 Ω connected to an ideal battery of emf12.0 V by means of two copper wires. Each wire has length 20.0 cm and radius 1.00 mm. In dealing with such circuits in this chapter, we generally neglect the potential differences along the wires and the transfer of energy to thermal energy in them. Check the validity of this neglect for the circuit of Figure: What is the potential difference across (a) The resistor and (b) Each of the two sections of wire? At what rate is energy lost to thermal energy in (c) The resistor And (d) Each section of wire?

$$\begin{gathered} R=6.00\Omega \\ \epsilon =12.0V \\ L=20.0cm=20.0\times {10}^{-2}m. \\ r=1.00mm=1.00\times {10}^{-3}m \end{gathered}$$

Find the current resistance of the wire from its resistivity using the corresponding formula. Then, using Ohm’s law, find the current through the circuit. Using this, easily find the resistance across the wire and the resistor using Ohm’s law. The formula for the power will give therate at which the energy is lost to the thermal energy in the two sections of the wire and the resistor.

Ohm's law states that the current through a conductor between two points is directly proportional to the voltage across the two points.

Formulae are as follow:

$R=\frac{\rho L}{A}$

Where, R is resistance,ρis resistivity, L is length, A is area.

The resistance across each copper wire is,

$R_w=\frac{\rho L}{A}$

$R_w=1.0756\times {10}^{-3}\Omega \approx 0.0011\Omega$

Therefore, the total resistance in the circuit is

$$\begin{gathered} R_{total}=2R_w+R \\ {R}_{total}=2(0.0011)+6.00 \\ {R}_{total}=6.0022\Omega \end{gathered}$$

Ohm’s law gives,

V=IR

$I=\frac{V}{R}$

In this case,

$I=\frac{12}{6.0022}$

I=1.9993A

The voltage across the resistor is

V=IR

V=1.9993(6)

=11.996=12V

Hence, potential difference across the resistor is 12.0V.

The voltage across each wire is,

$V_w=I{R}_w$

$\therefore V_w=2.15\times {10}^{-3}V$

Hence, potential difference across each of the two sections of wire is$\therefore V_w=2.15\times {10}^{-3}V$

It is known that,

P=IV

$$\begin{gathered} P=1.9993(11.996) \\ P=23.98~24W \end{gathered}$$

Hence, the rate at which energy is lost to thermal energy in the resistor is 24W

$$\begin{gathered} P_w=I{V}_w \\ {P}_w=1.9993(2.15\times {10}^{-3}) \\ {P}_w=4.298\times {10}^{-3}=4.30mW \end{gathered}$$

Hence, the rate at which energy is lost to thermal energy in the two sections of wire 4.30mW

Therefore,the potential difference andthe rate at which the energy is lost across the resistor and the wire in the circuit can be found using Ohm’s law and resistivity of material.