(a) Using the result of Problem 23 and 7.00eVfor copper’s Fermi energy, determine how much energy would be released by the conduction electrons in a copper coin with mass3.10g if we could suddenly turn off the Pauli exclusion principle. (b) For how long would this amount of energy light a100 Wlamp? (Note: There is no way to turn off the Pauli principle!)

Short Answer

Expert verified
  1. The amount of energy that would be released by the conduction electrons in a copper coin is 1.97×104J.
  2. This amount of energy will light a 100 lamp for 197 s.

Step by step solution

01

The given data

  1. Fermi energy of copper, EF=7eV
  2. Mass of copper coin,m=3.10g
  3. Molar mass of copper,A=63.54g/mol
  4. Power or the rate of energy used of the lamp, P = 100 W
02

Understanding the concept of energy

The transfer of energy from one body to another in unit time interval is known as power. It is also described as the rate of doing work with respect to time.

Formulae:

The average energy used by the a body,Eavg=35EF (i)

The total energy released by the conduction electrons,E=NEavg (ii)

where, N is the number of electrons present in the material and is the Fermi energy.

The rate of energy consumption, P = E /t (ii)

03

a) Calculation of the energy released by the conduction electrons

From equation (i) and equation (ii), we get -

E=mANA35EF

where,N=mass(m)molarmass(A)×avogadronumber(NA)=3.1g63.54g/mol6.022×1023/mol357eV1.6×10-19J/eV=1.97×104J

Hence, the value of the energy is .

04

b) Calculation of the time till which the lamp is light on

Using the above value of energy, we can get the time till which the energy is lit up as follows:

t=1.97×104J100J/s=197s

Hence, the value of the time is 197 s .

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

Doping changes the Fermi energy of a semiconductor. Consider silicon, with a gap of 1.11eV between the top of the valence band and the bottom of the conduction band. At 300K the Fermi level of the pure material is nearly at the mid-point of the gap. Suppose that silicon is doped with donor atoms, each of which has a state 0.15eV below the bottom of the silicon conduction band, and suppose further that doping raises the Fermi level to 0.11eV below the bottom of that band (Fig. 41-22). For (a) pure and (b) doped silicon, calculate the probability that a state at the bottom of the silicon conduction band is occupied. (c) Calculate the probability that a state in the doped material (at the donor level) is occupied.

What is the probability that a state 0.0620eV above the Fermi energy will be occupied at (a) T = OK and (b) T = 320K?

What is the probability that, at a temperature of T = 300 K, an electron will jump across the energy gapEg(=5.5eV) in a diamond that has a mass equal to the mass of Earth? Use the molar mass of carbon in Appendix F; assume that in diamond there is one valence electron per carbon atom.

When a photon enters the depletion zone of a p-njunction, the photon can scatter from the valence electrons there, transferring part of its energy to each electron, which then jumps to the conduction band. Thus, the photon creates electron–hole pairs. For this reason, the junctions are often used as light detectors, especially in the x-ray and gamma-ray regions of the electromagnetic spectrum. Suppose a single 662keV gamma-ray photon transfers its energy to electrons in multiple scattering events inside a semiconductor with an energy gap of 1.1eV, until all the energy is transferred. Assuming that each electron jumps the gap from the top of the valence band to the bottom of the conduction band, find the number of electron – hole pairs created by the process.

The compound gallium arsenide is a commonly used semiconductor, has an energy gap Egof1.43eV. Its crystal structure is like that of silicon, except that half the silicon atoms are replaced by gallium atoms and half by arsenic atoms. Draw a flattened-out sketch of the gallium arsenide lattice, following the pattern of Fig. 41-10a.What is the net charge of the (a) gallium and (b) arsenic ion core? (c) How many electrons per bond are there? (Hint:Consult the periodic table in Appendix G.)

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free