In Fig. 12-76, a uniform rod of mass m is hinged to a building at its lower end, while its upper end is held in place by a rope attached to the wall. If angleθ1=60°, what value must angleθ2 have so that the tension in the rope is equal to mg/2?

Short Answer

Expert verified

The exact angle θ2for which tension in the rope ismg2 is60°

Step by step solution

01

Understanding the given information

θ=60°

T=mg/2

02

Concept and formula used in the given question

Using the condition for equilibrium, you can find the required angle for the given tension in the rope. The equations are given below.

Fx=0Fy=0τ=0

03

Calculation for the what value must angle θ2 have so that the tension in the rope is equal to  mg/2

We know the condition of equilibrium in which the moment of force, and torque is zero.

From the figure, we can say that

(L2)×mgsinθ1(mg2sinθ2)×L=0sinθ12sinθ22=0sin602sinθ22=0sinθ2=0.8660θ2=600(L2)×mgsinθ1(mg2sinθ2)×L=0sinθ12sinθ22=0sin602sinθ22=0sinθ2=0.8660θ2=600

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

Question: Because gvaries so little over the extent of most structures, any structure’s center of gravity effectively coincides with its center of mass. Here is a fictitious example where gvaries more significantly. Figure 12-25 shows an array of six particles, each with mass m, fixed to the edge of a rigid structure of negligible mass. The distance between adjacent particles along the edge is 2.00 m. The following table gives the value of g (m/s2)at each particle’s location. Using the coordinate system shown, find (a) the xcoordinate xcom and (b) the ycoordinate Ycom of the center of mass of the six-particle system. Then find (c) the xcoordinate xcog and (d) the ycoordinateYcogof the center of gravity of the six-particle system.

Question: A uniform cubical crate is 0.750 m on each side and weighs 500 N . It rests on a floor with one edge against a very small, fixed obstruction. At what least height above the floor must a horizontal force of magnitude 350 N be applied to the crate to tip it?

A pan balance is made up of a rigid, massless rod with a hanging pan attached at each end. The rod is supported at and free to rotate about a point not at its center. It is balanced by unequal masses placed in the two pans. When an unknown mass mis placed in the left pan, it is balanced by a mass m1 placed in the right pan; when the mass mis placed in the right pan, it is balanced by a mass m2in the left pan. Show thatm=m1m2

In Fig. 12-44, a 15 kg block is held in place via a pulley system. The person’s upper arm is vertical; the forearm is at angleθ=30o with the horizontal. Forearm and hand together have a mass of 2.0 kg, with a center of mass at distance d1=15 cmfrom the contact point of the forearm bone and the upper-arm bone(humerus). The triceps muscle pulls vertically upward on the forearm at distanced2=2.5 cm behind that contact point. Distanced3is 35 cm. What are the (a)magnitude and (b) direction (up or down) of the force on the forearm from the triceps muscle and the (c) magnitude and (d) direction (up or down) of the force on the forearm from the humerus?

The system in Fig. 12-77 is in equilibrium. The angles are θ1=60°and θ2=20°, and the ball has mass M=2.0 kg. What is the tension in (a) string ab and (b) string bc?

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free