Three piñatas hang from the (stationary) assembly of massless pulleys and cords seen in Fig. 12-21. One long cord runs from the ceiling at the right to the lower pulley at the left, looping halfway around all the pulleys. Several shorter cords suspend pulleys from the ceiling or piñatas from the pulleys. The weights (in newtons) of two piñatas are given.

(a) What is the weight of the third piñata? (Hint:A cord that loops halfway around a pulley pulls on the pulley with a net force that is twice the tension in the cord.)

(b) What is the tension in the short cord labeled with T?

Short Answer

Expert verified

a) The weight of the third piñata is 15 N .

b) Tension in the short cord labelled is 10 N .

Step by step solution

01

The given data

The pulley system is in equilibrium, having various weights attached to it.

02

Understanding the concept of pulleys

We use the concept of balanced forces to determine the magnitudes of the various tensions and forces acting on the cords. We make use of free-body diagrams for pulleys.

Formulae:

The value of the net force at equilibrium, Fnet=0 (i)

03

a) Calculation of the weight of the third piñata

We will consider a free body diagram for each of the pulleys and balance the forces for each.

The tension in each part of the red rope is the same; this is as it wound continuously on the pulleys.

Let it be denoted as T'. Let, the tension in the green cords be denoted asF1,F2,F3 , and T as indicated in the diagram. Let the unknown weight be w.

We now consider the first pulley on the right side, to have weight 17 N hanging from it. The forces acting on this system are in each of the red ropesT'andF1in the green cord.

All three are directed upwards, whereas the weight is directed downwards.

Now, the net force equation for this pulley considering equation (i) can be given as:

F1+T'-17=0F1+2T'=17.................(i)

Similarly, for the next pulleys, we write the force equations using equation (i) as follows:

role="math" localid="1660977557551" 2T'=10...........(ii)F3-2T'=0............(iii)T-2T'=0.............(iv)3T'-w=0.............(v)

From equation (ii), we get,

T'=5N

And using this value of T’ in equation (v), we find,

w=15N

Hence, the value of the weight of the piñata is 15 N .

04

b) Calculation of the tension of the short labelled cord

Also, from equation (iv), we calculate the value of the tension using the value of

T'=5N can be calculated as:

T25N=0T=10N

Hence, the value of the tension of the short cord is 10 N .

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

Question: In Fig.12-35, horizontal scaffold 2, with uniform mass m2 =30.0 kg and length L2 =2.00 m, hangs from horizontal scaffold 1, with uniform mass m1 = 50 kg . A 20 kgbox of nails lies on scaffold 2, centered at distance d = 0.500 mfrom the left end. What is the tension Tin the cable indicated?

Figure 12-23 shows a horizontal block that is suspended by two wires, Aand B, which are identical except for their original lengths. The center of mass of the block is closer to wire Bthan to wire A.

(a) Measuring torques about the block’s center of mass, state whether the magnitude of the torque due to wire Ais greater than, less than, or equal to the magnitude of the torque due to wire B.

(b) Which wire exerts more force on the block?

(c) If the wires are now equal in length, which one was originally shorter (before the block was suspended)?

The table gives the initial lengths of three rods and the changes in their lengths when forces are applied to their ends to put them under strain. Rank the rods according to their strain, greatest first.

A uniform ladder is 10 m long and weighs 200 N . In Fig. 12-78, the ladder leans against a vertical, frictionless wall at heighth=8.0 m above the ground. A horizontal force is applied to the ladder at distance d=2.0 mfrom its base (measured along the ladder).

(a) If force magnitudeF=50 N , what is the force of the ground on the ladder, in unit-vector notation?

(b) IfF=150 N , what is the force of the ground on the ladder, also in unit-vector notation?

(c) Suppose the coefficient of static friction between the ladder and the ground is0.38 for what minimum value of the force magnitude Fwill the base of the ladder just barely start to move toward the wall?

A gymnast with mass46.0 kg stands on the end of a uniform balance beam as shown in Fig. 12-80. The beam is 5.00 m long and has a mass of250 kg (excluding the mass of the two supports). Each support is0.540m  from its end of the beam. In unit-vector notation, what are the forces on the beam due to (a) support 1 and (b) support 2?

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free