A circular curve of highway is designed for traffic moving at 60 km/h. Assume the traffic consists of cars without negative lift. (a) If the radius of the curve is 150 m, what is the correct angle of banking of the road? (b) If the curve were not banked, what would be the minimum coefficient of friction between tires and road that would keep traffic from skidding out of the turn when traveling at60 km/h?

Short Answer

Expert verified

(a) The correct angle of banking of the road is θ=11°.

(b) The minimum coefficient of friction between tires and road is μs=0.19.

Step by step solution

01

Given data:

Consider the given data as below.

The radius of curve, R =150 m

Speed of the car is,

vmax=60km/h=60km/h×1m/s3.6km/g=16.7m/s

As known, that,

Acceleration due to gravity,g=9.8m/s2

02

Understanding the concept:

Consider that the car is “on the verge of sliding out” – meaning that the force of static friction is acting “down the bank” (or “downhill” from the point of view of an ant on the banked curve) with maximum possible magnitude. First, consider the vector sum Fof the (maximum) static friction force and the normal force.

Due to the fact that they are perpendicular and their magnitudes are simply proportional (Eq. 6-1), you can find Fis at an angle (measured from the vertical axis) ϕ=θ+θs, where tanθs=μs(compare with Eq. 6- 13), and θis the bank angle.

Now, the vector sum of F and the vertically downward pull (mg)of gravity must be equal to the (horizontal) centripetal force mv2R, which leads to a surprisingly simple relationship:

tanϕ=mv2/Rmg=v2Rg

Writing this as an expression for the maximum speed, you have

role="math" localid="1661151842310" vmax=Rgtanθ+tan-1μs

vmax=Rgtanθ+μs1-μstanθ ….. (1)

03

Calculate the correct angle of banking of the road if the radius of the curve is 150m:

Note that the given speed is (in SI units) roughly 17 m/s .

If you do not want the cars to “depend” on the static friction to keep from sliding out (that is, if you want the component “down the back” of gravity to be sufficient), then you can set μs=0in the equation (1), and you obtain

vmax=Rgtanθ+01-0tanθ=Rgtanθ+01=Rgtanθ+0

vmax2=Rgtanθθ=tan-1vmax2Rg

Substitute the known values in the above equation.

θ=tan-116.7m/s2150m9.8m/s2=tan-1278.89m2/s21470m2/s2=tan-10.189=10.7°θ11°

Hence, the correct angle of banking of the road is 11°.

04

The minimum coefficient of friction between tires and road:

Calculate the minimum coefficient of friction between tires and road that would keep traffic from skidding out of the turn when traveling at if the curve were not banked

If, however, the curve is not banked (soθ=0°) then the above expression becomes

v=Rgtantan-1μs=Rgμs

Solving this for the coefficient of static friction, you get

v2=Rgμsμs=v2Rg

Substitute known values in the above equation.

μs=16.7m/s2150m9.8m/s2=278.89m2/s21470m2/s2=0.19

Hence, the minimum coefficient of friction between tires and road is 0.19.

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

During a routine flight in 1956, test pilot Tom Attridge put his jet fighter into a20°dive for a test of the aircraft’s 20 mmmachine cannons. While traveling faster than sound at 4000 m altitude, he shot a burst of rounds. Then, after allowing the cannons to cool, he shot another burst at 2000 m; his speed was then344 m/s, the speed of the rounds relative to him was 730 m/s, and he was still in a dive. Almost immediately the canopy around him was shredded and his right air intake was damaged. With little flying capability left, the jet crashed into a wooded area, but Attridge managed to escape the resulting explosion. Explain what apparently happened just after the second burst of cannon rounds. (Attridge has been the only pilot who has managed to shoot himself down.)

You must push a crate across a floor to a docking bay. The crate weighs 165 N. The coefficient of static friction between crate and floor is 0.510, and the coefficient of kinetic friction is 0.32. Your force on the crate is directed horizontally. (a) What magnitude of your push puts the crate on the verge of sliding? (b) With what magnitude must you then push to keep the crate moving at a constant velocity? (c) If, instead, you then push with the same magnitude as the answer to (a), what is the magnitude of the crate’s acceleration?

In Fig. 6-60, a block weighing22 Nis held at rest against a vertical wall by a horizontal force of magnitude 60 N .The coefficient of static friction between the wall and the block is 0.55 , and the coefficient of kinetic friction between them is 0.38 . In six experiments, a second force is applied to the block and directed parallel to the wall with these magnitudes and directions: (a) 34 N , up, (b) 12 N , up, (c) 48 N , up, (d) 62 N, up, (e) 10 N , down, and (f) 18 N, down. In each experiment, what is the magnitude of the frictional force on the block? In which does the block move (g) up the wall and (h) down the wall? (i) In which is the frictional force directed down the wall?

A roller-coaster car at an amusement park has a mass of1200kgwhen fully loaded with passengers. As the car passes over the top of a circular hill of radius18m, assume that its speed is not changing. At the top of the hill, what are the (a) magnitudeFNand (b) direction (up or down) of the normal force on the car from the track if the car’s speed isV=11m/s? What are (c)FNand (d) the direction ifV=14m/s?

In Fig. 6-59, block 1 of massm1=2.0kgand block 2 of massm2=1.0kgare connected by a string of negligible mass. Block 2 is pushed by force of magnitude 20 Nand angleθ=35°. The coefficient of kinetic friction between each block and the horizontal surface is 0.20. What is the tension in the string?

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free