In Fig.16-42, a string, tied to a sinusoidal oscillator at Pand running over a support at Q, is stretched by a block of mass m. Separation L = 1.20 m, linear density, μ=1.6g/mand the oscillator frequency,. The amplitude of the motion at Pis small enough for that point to be considered a node. A node also exists atQ. (a) What mass mallows the oscillator to set up the fourth harmonicon the string? (b) What standing wave mode, if any, can be set up if m = 1.00 kg?

Short Answer

Expert verified
  1. Mass of 0.846 kg allows the oscillator to set up the fourth harmonic on the string
  2. No standing wave mode can be set up if 1.0 kg

Step by step solution

01

Given data

The separation between oscillation and the mass, L = 1.2 m

The linear density of the string,μ=1.6g/mor1.6×10-3kg/m

The oscillator frequency, f = 120 Hz

Mass of the block = m

02

Understanding the concept of harmonic oscillation

We know the equation for the frequency of a standing wave and the velocity of the wave. Using both of these equations, we can find the required mass which allows the oscillator to set up the fourth harmonic on the string.

Using the same formulae we used earlier we can find the wave mode which can be set up when m = 1.00 kg

Formulae:

The frequency of nth harmonic oscillation, f=n2L×τμ.........1

The velocity of the wave, v=τμ...........(2)

The tension of the string, τ=mg........(3)

n = 4.......(4) for fourth harmonic

03

Step 3(a): Calculation of mass that would set up fourth harmonic oscillation

Rearranging equation (1), we get the given form as:

2Lfn=τμ2Lfn=mgμ2Lfn2=mgμwetakesquaresonbothsides,m=1.6×10-39.82×1.2×12042m=μmg×2Lfn2=1.6×10-39.82×1.2×1204substitutingthegivenvalues=0.846kg

Hence, the required value of mass is 0.846 kg

04

Step 4(b): Calculation of standing wave mode if m = 1.00 kg

Again rearranging equation (1), we get the form as given:

n=2Lf×μτ=2Lf×μmg=2×1.2×120×1.6×10-31.0×9.8=3.68

As the calculated answer is not an integer, hence, no standing wave can be set up on the given wave.

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

(a) What is the fastest transverse wave that can be sent along a steel wire? For safety reasons, the maximum tensile stress to which steel wires should be subjected is 7.00x1018N/m2.The density of steel is7800kg/m3. (b) Does your answer depend on the diameter of the wire?

A continuous traveling wave with amplitude Ais incident on a boundary. The continuous reflection, with a smaller amplitude B, travels back through the incoming wave. The resulting interference pattern is displayed in Fig. 16-51. The standing wave ratio is defined to beSWR=A+BA-B

The reflection coefficient Ris the ratio of the power of the reflected wave to thepower of the incoming wave and is thus proportional to the ratio (BA)2. What is the SWR for (a) total reflection and (b) no reflection? (c) For SWR = 1.50, what is expressed as a percentage?

A rope, under a tension of 200 Nand fixed at both ends, oscillates in a second-harmonic standing wave pattern. The displacement of the rope is given by y=(0.10m)(sinπx/2)sin12πt , where x = 0at one end of the rope, x is in meters, andis in seconds. What are (a) the length of the rope, (b) the speed of the waves on the rope, and (d) the mass of the rope? (d) If the rope oscillates in a third-harmonic standing wave pattern, what will be the period of oscillation?

What are (a) the lowest frequency, (b) the second lowest frequency, and (c) the third lowest frequency for standing waves on a wire that is10.0 m long, has a mass of 100 g, and is stretched under a tension of 250 N?

One of the harmonic frequencies for a particular string under tension is 325 Hz.The next higher harmonic frequency is 390 Hz. What harmonic frequency is next higher after the harmonic frequency 195 Hz?

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free