A sound source moves along an xaxis, between detectors Aand B. The wavelength of the sound detected at Ais0.500that of the sound detected at B. What is the ratiovs/vof the speed of the source to the speed of sound?

Short Answer

Expert verified

The ratio of the speed of source to the speed of sound will be 13.

Step by step solution

01

The given data

The wavelength detected at detector A to that of detector B, λB=0.5λA.

02

Understanding the concept of the wave equations

We are given the wavelengths detected at A and B. Using these and the formula for frequency in terms of velocity, we can find the ratio of the speed of the source to the speed of sound.

Formula:

The frequency of a wave,

f=vλ …(i)

The frequency received by the observer according to Doppler’s Effect, (for observer at rest and source moving towards it)

f'=f(vvvS) …(ii)

03

Calculation of the ratio of the speed of source to that of sound

For detector A, using equation (ii), we get

fA'=fvvvS

For detector B, using equation (ii), we get

fB'=fvv+vS

We take the ratio for the above two equations of the frequencies, we get

fB'fA'=fvv+vSfvvvS

fB'fA'=vvSv+vS …(a)

Using value of frequencies from equation (i) in equation (a), we get

vλBvλA=(1vS)v(1+vS)vλBλA=1vsv1+vsv

λB=0.5λA

So,

0.5λAλA=1vsv1+vsv0.5=1vsv1+vsv

12=1vsv1+vsv12×1+vsv=1vsv12+12vsv=1vsv32vsv=11232vsv=12vsv=23×12=13

Hence, the value of the required ratio is 1/3.

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

The speed of sound in a certain metal is vm. One end of a long pipe of that metal of length Lis struck a hard blow. A listener at the other end hears two sounds, one from the wave that travels along the pipe’s metal wall and the other from the wave that travels through the air inside the pipe.

(a) Ifrole="math" localid="1661511418960" V is the speed of sound in air, what is the time intervalΔt between the arrivals of the two sounds at the listener’s ear?

(b) IfΔt=1.00 sand the metal is steel, what is the lengthL?

Question: A column of soldiers, marching at 120paces per minute, keep in step with the beat of drummer at the head of the column. The soldiers in the rear end of the column are striding forward with the left foot when the drummer is advancing with the right foot. What is the approximate length of the column?

Question: Two loud speakers are located 3.35 mapart on an outdoor stage. A listener is18.3m from one andfrom the other. During the sound check, a signal generator drives the two speakers in phase with the same amplitude and frequency. The transmitted frequency is swept through the audible range 20Hz to 20 KHz. (a) What is the lowest frequency fmin1that gives minimum signal (destructive interference) at the listener’s location? By what number must fmin1be multiplied to get(b)The second lowest frequencyfmin2that gives minimum signal and(c)The third lowest frequencyfmin3that gives minimum signal ?(d)What is the lowest frequencyfmin1that gives maximum signal (constructive interference) at the listener’s location ? By what number mustfmin1be multiplied to get(e) the second lowest frequencyfmin2that gives maximum signal and(f) the third lowest frequencyfmin3that gives maximum signal?

Figure 17-48 shows an air-filled, acoustic interferometer, used to demonstrate the interference of sound waves. Sound source Sis an oscillating diaphragm; Dis a sound detector, such as the ear or a microphone. PathSBDcan be varied in length, but pathSADis fixed. At D, the sound wave coming along pathinterferes with that coming along pathSAD. In one demonstration, the sound intensity at Dhas a minimum value of 100 units at one position of the movable arm and continuously climbs to a maximum value of 900 units when that arm is shifted by 1.65 cm. Find (a) the frequency of the sound emitted by the source and (b) the ratio of the amplitude at Dof the SADwave to that of the SBDwave. (c) How can it happen that these waves have different amplitudes, considering that they originate at the same source?

In Fig. 17-46, sound of wavelength 0.850 mis emitted isotropically by point source S. Sound ray 1 extends directly to detector D, at distance L=10.0 m. Sound ray 2 extends to Dvia a reflection (effectively, a “bouncing”) of the sound at a flat surface. That reflection occurs on a perpendicular bisector to the SDline,at distance dfrom the line. Assume that the reflection shifts the sound wave by0.500λ. For what least value of d(other than zero) do the direct sound and the reflected sound arrive at D(a) exactly out of phase and (b) exactly in phase?

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free