The photon energy for green light lies between the values for red and violet light. What is the approximate energy of the photons in green light? The intensity of sunlight above the Earth’s atmosphere is about 1400 W (J/s) per square meter. That is, when sunlight hits perpendicular to a square meter of area, about 1400 W of energy can be absorbed. Using the photon energy of green light, about how many photons per second strike an area of one square meter? (This is why the lumpiness of light was not noticed for so long.)

Short Answer

Expert verified

The approximate energy of the photons of green light is3.643×10-19J

3.84×1021 photons per second strike an area of one square meter.

Step by step solution

01

About Energy of photons and Definition of intensity of light

Energy of photons of light is defined as the energy carried by the photons and it is directly proportional to the light’s frequency.

The energy of a single photon is expressed as, E=fhwhere, Eis Energy of a single photon, fis frequency of light and 6.626×10-34Js is Planck’s constant.

Intensity of light is defined as power per unit area per unit time.

The intensity of sunlight falling on Earth’s surface is the energy received by the Earth’s curved surface area in one second.

02

Calculation of energy of photons of green light

Frequency of green light isf=550×1012Hz.

Substitute value of frequency and Planck’s constant into formula of energy of single photon.

E=550×1012×6.626×10-34=3.643×10-19J

Therefore, the approximate energy of the photons of green light is3.643×10-19 .

03

Calculation of number of photons of green light

Given that, the intensity of sunlight above the Earth’s atmosphere is about 1400Wper square meter.

The formula for intensity of light is, l=NEtAwhere lis intensity of light, N is number of photons, E is energy of single photon, t is time duration and A is area of the surface.

The number of photons falling on unit area in unit time isN=ltAE

Substitute the values into the obtained formula to obtain the required number of photon.

N=1400J/sm2×1s×1m23.643×10-19J=3.84×1021

Thus, the approximate energy of the photons of green light is3.643×10-19J and3.84×1021 photons per second strike an area of one square meter.

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

Some material consisting of a collection of microscopic objects is kept at a high temperature. A photon detector capable of detecting photon energies from infrared through ultraviolet observes photons emitted with energies of0.3eV,0.5eV,0.8eV,2,0eV,2.5eV,and2.8eV. These are the only photon energies observed. (a) Draw and label a possible energy-level diagram for one of the microscopic objects, which has four bound states. On the diagram, indicate the transitions corresponding to the emitted photons. Explain briefly. (b) Would a spring–mass model be a good model for these microscopic objects? Why or why not? (c) The material is now cooled down to a very low temperature, and the photon detector stops detecting photon emissions. Next, a beam of light with a continuous range of energies from infrared through ultraviolet shines on the material, and the photon detector observes the beam of light after it passes through the material. What photon energies in this beam of light are observed to be significantly reduced in intensity (“dark absorption lines”)? Explain briefly.

A hot bar of iron glows a dull red. Using our simple ball-spring model of a solid (Figure 8.23), answer the following questions,explaining in detail the processes involved. You will need to make some rough estimates of atomic properties based on prior work. (a) What is the approximate energy of the lowest-energy spectral emission line? Give a numerical value. (b) What is the approximate energy of the highest-energy spectral emission line? Give a numerical value. (c) What is the quantum number of the highest-energy occupied state? (d) Predict the energies of two other lines in the emission spectrum of the glowing iron bar. (Note: Our simple model is too simple-the actual spectrum is more complicated. However, this simple analysis gets at some important aspects of the phenomenon.)

Consider a microscopic spring–mass system whose spring stiffness is50N/m, and the mass is4×10-26kg. (a) What is the smallest amount of vibrational energy that can be added to this system? (b) What is the difference in mass (if any) of the microscopic oscillator between being in the ground state and being in the first excited state? (c) In a collection of these microscopic oscillators, the temperature is high enough that the ground state and the first three excited states are occupied. What are possible energies of photons emitted by these oscillators?

At t =0 all of the atoms in a collection of 10000 atoms are in a excited state whose lifetime is 25 ns. Approximately how many atoms will still be in excited state at t= 12 ns.

Suppose we have reason to suspect that a certain quantum object has only three quantum states. When we excite such an object we observe that it emits electromagnetic radiation of three different energies: 2.48eV(green), 1.91eV(orange), and 0.57eV(infrared). (a) Propose two possible energy-level schemes for this system. (b) Explain how to use an absorption measurement to distinguish between the two proposed schemes.

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free