Suppose we have a reason to suspect that a certain quantum object has only three quantum states.When we excite a collection of such objects we observe that they emit electromagnetic radiation of three different energies: 0.3eV(infrared), 2.0eV(visible), and 2.3eV(visible).

(a) Draw a possible energy-level diagram for one of the quantum objects, which has three bound states. On the diagram, indicate the transitions corresponding to the emitted photons, and check that the possible transitions produce the observed photons and no others. The energyK+U of the ground state is -4eV. Label the energies of each level ( K+U, which is negative).

(b) The material is now cooled down to a very low temperature, and the photon detector stops detecting photon emissions. Next a beam of light with a continuous range of energies from infrared through ultraviolet shines on the material, and the photon detector observes the beam of light after it passes through the material. What photon energies in this beam of light are observed to be significantly reduced in intensity ("dark absorption lines")? Energy of highest-energy dark line: eV Energy of lowest-energy dark line: eV

(c) There exists another possible set of energy levels for these objects which produces the same photon emission spectrum. On an alternative energy-level diagram, different from the one you drew in part (a), indicate the transitions corresponding to the emitted photons, and check that the possible transitions produce the observed photons and no others. When you are sure that your alternative energy-level diagram is consistent with the observed photon energies, enter the energies of each level (K+U, which is negative).

(d) For your second proposed energy-level scheme, what photon energies would be observed to be significantly reduced in intensity in an absorption experiment ("dark absorption lines")? (Given the differences from part (b), you can see that an absorption measurement can be used to tell which of your two energy-level schemes is correct).

Short Answer

Expert verified

a.

b. The photon energies observed by the light beam are 2 eVand 2.3 eVrespectively.

c.

d. The photon energies observed by the light beam are0.3 eV and 2.3 eVrespectively.

Step by step solution

01

Identification of the given data

The given data can be listed below as:

  • The first emitted energy is E1=0.3 eV.
  • The second emitted energy is E2=2.0 eV.
  • The third emitted energy is E3=2.3 eV.
  • The ground state energy is E0=4 eV.
02

Significance of the energy level diagram

The energy level diagram is described as the diagram of the different discrete level of energy. This diagram also has both vibrational and electronic states.

03

(a) Determination of the energy level diagram

The energy level diagram has been drawn below:

In the diagram, it has been identified that the transition occurring from the first or second excited state to the ground state. The energies are 4 eV, 2 eVand1.7 eV respectively.

THUS,

04

(b) Determination of the photon energies

As the quantum object has no emission energy at the ground state, then if the laser is being pointed into the system and gradually the energy is increased, then it can be identified that the system will jump from the ground state to the first and the second excited state which are2 eV and2.3 eV respectively.

Thus, the photon energies observed by the light beam are2 eV and 2.3 eVrespectively.

05

(c) Determination of the transition and labelling the energy

The diagram has been drawn below:

In the above diagram, the difference is from the above diagram to the diagram in part (a) is the excited level’s position. The transition is that the energy falls from the higher excited states to the lower excited states.

THUS,

06

(d) Determination of the photon energies

As the quantum object has no emission energy at the ground state, then if the laser is being pointed into the system and gradually the energy is increased, then it can be identified that the system will jump from the ground state to the first and the second excited state which are0.3 eV and2.3 eV respectively.

Thus, the photon energies observed by the light beam are0.3 eV and 2.3 eVrespectively.

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

Energy graphs: (a) Figure 8.41 shows a graph of potential energy vs. interatomic distance for a particular molecule. What is the direction of the associated force at location A? At location B? At location C? Rank the magnitude of the force at locations A,B and C. (That is, which is greatest , which is smallest, and are any of these equal to each other?) For the energy level shown on the graph, draw a line whose height is the kinetic energy when the system is at location D.

(b) Figure 8.42 shows all of the quantized energies (bound states) for one of these molecules. The energy for each state is given on the graph, in electron volts ( 1eV=1.6×1019J). How much energy is required to break a molecule apart, if it is initially in the ground state? (Note that the final state must be an unbound state; the unbound states are not quantized.)

(c) At high enough temperatures, in a collection of these molecules there will be at all times some molecules in each of these states, and light will be emitted. What are the energies in electron volts of the emitted light?

(d) The "inertial" mass of the molecule is the mass that appears in Newton's second law, and it determines how much acceleration will result from applying a given force. Compare the inertial mass of a molecule in the ground state and the inertial mass of a molecule in an excited state10eV above the ground state. If there is a difference, briefly explain why and calculate the difference. If there isn't a difference, briefly explain why not.)

Assume that a hypothetical object has just four quantum states, with the energies shown in Figure 8.43.

(a) Suppose that the temperature is high enough that in a material containing many such objects, at any instant some objects are found in all of these states. What are all the energies of photons that could be strongly emitted by the material? (In actual quantum objects there are often “selection rules” that forbid certain emissions even though there is enough energy; assume that there are no such restrictions here.) (b) If the temperature is very low and electromagnetic radiation with a wide range of energies is passed through the material, what will be the energies of photons corresponding to missing (“dark”) lines in the spectrum? (Assume that the detector is sensitive to a wide range of photon energies, not just energies in the visible region.)

A certain material is kept at very low temperature. It is observed that when photons with energies between 0.2 and 0.9 eV strike the material, only photons of 0.4 eV and 0.7 eV are absorbed. Next, the material is warmed up so that it starts to emit photons. When it has been warmed up enough that 0.7 eV photons begin to be emitted, what other photon energies are also observed to be emitted by the material? Explain briefly.

A hot bar of iron glows a dull red. Using our simple ball-spring model of a solid (Figure 8.23), answer the following questions,explaining in detail the processes involved. You will need to make some rough estimates of atomic properties based on prior work. (a) What is the approximate energy of the lowest-energy spectral emission line? Give a numerical value. (b) What is the approximate energy of the highest-energy spectral emission line? Give a numerical value. (c) What is the quantum number of the highest-energy occupied state? (d) Predict the energies of two other lines in the emission spectrum of the glowing iron bar. (Note: Our simple model is too simple-the actual spectrum is more complicated. However, this simple analysis gets at some important aspects of the phenomenon.)

Match the description of a process with the corresponding arrow in figure 8.38: (a) Absorption of a photon whose energy is E1-E0. (b) Absorption from an excited state (a rare event at ordinary temperatures). (c) Emission of a photon whose energy isE3-E1 . (d) Emission of a photon whose energy isE2-E0 . (e) In drawing arrows to represent energy transitions, which of the following statement are correct. (1) it doesn’t matter in which direction you draw the arrow as long as it connects the initial and final states. (2) For emission, the arrow points down. (3) For absorption, the arrow points up. (4) The tail of the arrow is drawn on the initial state. (5) The head of the arrow is drawn on the final state. (6) It is not necessary to draw and arrowhead.

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free