Describe a situation in which it would be appropriate to neglect the effects of air resistance.

Short Answer

Expert verified

A large item in free fall with a limited area (such as a dense pebble) that descends for a short duration.

Step by step solution

01

Definition of Air resistance force

  • The force caused by air is known as air resistance.
  • When an object moves through the air, the force acts in the opposite direction.
  • The formula used isFair=12CρAv2 .
02

Explanation of Air resistance force

From the above definition, find the scenarios in which effects of air resistance can be ignored.

  • Objects moving at a low speed (small value of v). As a result, when an object begins to descend, the effects of air resistance are barely noticeable. When the item has achieved a relatively high speed, however, the effects of air resistance become more apparent (especially if the terminal speed has been reached).
  • Objects with a low coefficient of drag (small value of C ). This is determined by the object's form and interaction with the surrounding air.
  • Pebbles, for example, are little objects with a small surface area (small value of A).
03

Considering the scenario of an object in free fall

Increasing the bulk of the object is a less visible means of reducing the effects of air resistance.

Write the equation for the scenario for an object in free fall.

Fy=mg-12CpAv2=ma=g-CpAv22m=a

When mthe above equation will become a=g.

As a result, another scenario in which it is reasonable to disregard air resistance are as follows:

  • Massive (dense) objects in free fall.
  • Any combination of the preceding scenarios. Consider a big object with a large surface area.

However, there are times when all of the qualities justify (or oppose) disregarding air resistance. A good illustration is a somewhat big item in free fall with a very small area (such as a dense pebble) that falls for a short period of time (otherwise its speed would eventually increase up to the terminal speed).

Therefore, A large item in free fall with a limited area (such as a dense pebble) that descends for a short duration.

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

Question: A mass of 0.3 Kghangs motionless from a vertical spring whose length is 0.8 mand whose unstretched length is 0.65 m. Next the mass is pulled down so the spring has a length of 0.9 mand is given an initial speed upward of 1.2 m/s. What is the maximum length of the spring during the following motion? What approximations or simplifying assumptions did you make?

You drag a block with constant speedacross a table with friction. Explain in detail what you have to do in order to change to a constant speed of 2von the same surface. (That is, the puzzle is to explain how it is possible to drag a block with sliding friction at different constant speeds.)

Question: Figure 7.48 is a portion of a graph of energy terms vs, time for a mass on a spring, subject to air resistance. Identify and label the three curves as to what kind of energy each represents. Explain briefly how you determined which curve represented which kind of energy.

Question: In the Niagara Falls hydroelectric generating plant, the energy of falling water is converted into electricity. The height of the falls is about 50m. Assuming that the energy conversion is highly efficient, approximately how much energy is obtained from one kilogram of falling water? Therefore, approximately how many kilograms of water must go through the generators every second to produce a megawatt of power 1 X 106W?

You are standing at the top of a 50 mcliff. You throw a rock in the horizontal direction with speed 10 m/s. If you neglect air resistance, where would you predict it would hit on the flat plain below? Is your prediction too large or too small as a result of neglecting air resistance?

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free