A ball is kicked on Earth from a location<9,0,-5> (on the ground) with initial velocity role="math" localid="1656668041027" <-10,13,-5>m/s . Neglecting air resistance: (a) What is the velocity of the ball 0.6 s after being kicked? (b) What is the location of the ball 0.6 s after being kicked? (c) What is the maximum height reached by the ball?

Short Answer

Expert verified

a) The velocity of the balls after the time of 0.6 s is -10,7,12,-5m/s.

b) The location of the balls after the time of 0.6 s is role="math" localid="1656668244576" 3,6.06,-8m.

c) The value of maximum height. of the ball is 8.622m.

Step by step solution

01

Identification of the given data

The given data can be listed below as:

  • The location of the point from where the ball has been kicked is 9,0,-5m
  • The initial velocity of the ball when it was kicked is -10,13,-5m
02

Explanation of the velocity and first and third equation of motion

The velocity of the car has two crucial factors that are magnitude and direction, and hence it is the vector quantity. The time and displacement are the dependent factors of the velocity.

The relation of the final and initial velocity of an object with the time used to obtain the value of acceleration is explained by the first equation of motion. It is expressed as follows:

v=u+at

Here, v is the final velocity, u is the initial velocity, a is the acceleration, and t is the time taken.

In the effect of uniform acceleration and knowing the value of initial velocity and distance traveled by a specific item, the final velocity can be determined using the thirst equation of motion. It is expressed as follows:

v2=u2+2as

Here, s is the distance.

03

Determination of the velocity of the balls after the time of 0.6 s

(a)

Write the expression for the velocity of the ball in the y-direction as the motion is vertical.

Take the y component from the coordinate point of velocity and use the first equation of motion.

v=13-9.8×0.6=7.12m/s

Thus, the velocity of the balls after the time of 0.6 s is -10,7,12,-5m/s.

04

Determination of the location of the balls after the time of 0.6 s

(b)

Determine the average velocity of the ball by finding the average of the y-component in the coordinate point of the velocity.

vavg=-10,13+7.122,-5m/s=-10,10.06,-5m/s

Determine the distance by multiplying the time in the coordinate point of the velocity.

d'=10×0.6,10.06×0.6,5×0.6=6,6.036,3m

Determine the location of the ball by adding the above distance in the coordinate point of location.

d=9-6,0+6.036,-5-3=3,6.036,-8m

Thus, the location of the balls after the time of 0.6 s is 3,6.036,-8m.

05

Determination of the maximum height attained by the ball

(c)

It is known that at the maximum height, the ball's final velocity will be zero. So, use the third equation of motion and determine the value of maximum height.

0=u2+2as

Here, a is the acceleration which is equal to the acceleration due to gravity in the upward direction, that is, -g=-9.8m/s2.

Substitute all the values in the above expression.

0=u2+2-gsu2=2gss=u22g=13m/s229.8m/s2=8.622m

Thus, the value of the maximum height of the ball is 8.622m.

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

Question: The following questions refer to the circuit shown in Figure 18.114, consisting of two flashlight batteries and two Nichrome wires of different lengths and different thicknesses as shown (corresponding roughly to your own thick and thin Nichrome wires).



The thin wire is 50 cm long, and its diameter is 0.25 mm. The thick wire is 15 cm long, and its diameter is 0.35 mm. (a) The emf of each flashlight battery is 1.5 V. Determine the steady-state electric field inside each Nichrome wire. Remember that in the steady state you must satisfy both the current node rule and energy conservation. These two principles give you two equations for the two unknown fields. (b) The electron mobility

in room-temperature Nichrome is about 7×10-5(ms)(Ns). Show that it takes an electron 36 min to drift through the two Nichrome wires from location B to location A. (c) On the other hand, about how long did it take to establish the steady state when the circuit was first assembled? Give a very approximate numerical answer, not a precise one. (d) There are about 9×1028mobile electrons per cubic meter in Nichrome. How many electrons cross the junction between the two wires every second?

Apply the general results obtained in the full analysis of motion under the influence of a constant force in Section 2.5 to answer the following questions. You hold a small metal ball of mass m a height h above the floor. You let go, and the ball falls to the floor. Choose the origin of the coordinate system to be on the floor where the ball hits, with y up as usual. Just after release, what are yi and vyi? Just before hitting the floor, what is yf? How much time ∆t does it take for the ball to fall? What is vfy just before hitting the floor? Express all results in terms of m, g, and h. How would your results change if the ball had twice the mass?

The position of a golf ball relative to the tee changes from<50,20,30>m to<53,18,31>m in0.1second. As a vector, write the velocity of the golf ball during this short time interval.

SLAC, the Standford Linear Accelerator Center, located at Stanford University in Palo Alto California, accelerates electrons through a vacuum tube 2 mi long (it can be seen from an overpass of the Junipero Serra freeway that goes right over the accelerator). Electrons that are initially at rest are subjected to a continuous force of 2×10-12 newton along the entire length of 2 mi (1 mi is 1.6 km) and reach speeds very near the speed of light. (a) Determine how much time is required to increase the electron's speed from 0.93c to 0.99c. (that is the quantity role="math" localid="1657119037340" |ν|/c increases from0.93c to 0.99c .) (b) Approximately how far does the electron go in this time? What is approximate about your result?

Consider the three experiments described in Problem 30. Figure 2.58 displays four graphs of Fnet, x, the x component of the net force acting on the cart, vs. time. The graphs start when the cart is at rest, and end when the cart is again at rest. Match the experiment with the graph

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free