A particle experiences a potential energy given byU(x)=(x2-3)e-x2

  1. Make a sketch of ofU(x), with numerical values of minima and maxima.
  2. What is the maximum energy that a particle can have and yet be bound?
  3. What is the maximum energy that a particle can have and yet be bound for a considerable amount of time?
  4. Is it possible for a particle to have more energy than in part (c) and still be bound for some period of time?

Short Answer

Expert verified

a.

(b)must be no greater than zero.

(c)Energy is between 0 ande-4.

(d)Yes,it might “bounce back and forth” for some time.

Step by step solution

01

Definition of bound state

Bound state is a state in quantum physics in which when a particle is provided with a potential energy, it tends to remain in the one or more regions of the state.

The maxima and minima of a given functionfx, can be easily calculated by finding solution of the equationf'x=0,where, f'xrepresents the differential of functionfx.

02

Given equations

In the given scenario, particle is subject to the following potential energy:

U(x)=(x2-3)e-x2

03

Calculations

In order to find the maximum and minimum value of the energy, we need to equate the differential of the given energy to zero.

ddxx2-3e-x2=2x+x2-3-2xe-x2ddxx2-3e-x2=-2x2+8xe-x2=0x=0,±2,±

Hence, the energy will have its extreme positions atx=±, x=0andx=±2

Atx=±,ψx=0.

Atx=0,ψx=-3.

At x=±2, ψx=e-4.

Step 3: (a) Explanation

By taking into account the values of energies on the extremities of the energy given, the following graph can be plotted.

It can be clearly seen in the above-mentioned graph that the extremities lie on the values -2, 0 and +2 and those aree-4, -3 and e-4respectively.

04

(b) Explanation

It would only be confined eternally if it was "below the walls" on both sides and unable to tunnel, meaning that the walls did not subsequently dip below the total energy. E has to be less than zero for this to hold true.

Hence, Energy must not be greater than zero.

05

(c) Explanation

The particle would be bound classically but could quantum mechanically tunnel if it were below the walls but above the point at which the walls extend further out. This is the case if the energy is between 0 and e-4.

Hence, Energy should be between 0 ande-4

06

(d) Explanation

Yes. Even if it is conventionally unbound over the tops of the walls, there is a quantum mechanical possibility of reflection at potential energy changes, thus it may "bounce back and forth" for a while.

Hence, yes, it might “bounce back and forth” for some time.

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

A function f(α)is nonzero only in the region of width 2δcentered atα=0

f(α)={Cαδ0αδ

where C is a constant.

(a) Find and plot versus βthe Fourier transform A(β)of this function.

(b) The function ρα) might represent a pulse occupying either finite distance (localid="1659781367200" α=position) or finite time (α=time). Comment on the wave number if α=is position and on the frequency spectrum if αis time. Specifically address the dependence of the width of the spectrum on δ.

Exercise 81 obtained formulas for hydrogen like atoms in which the nucleus is not assumed infinite, as in the chapter, but is of mass,m1 whilem2is the mass of the orbiting negative charge. (a) What percentage error is introduced in the hydrogen ground-state energy by assuming that the proton is of infinite mass? (b) Deuterium is a form of hydrogen in which a neutron joins the proton in the nucleus, making the nucleus twice as massive. Taking nuclear mass into account, by what percent do the ground-state energies of hydrogen and deuterium differ?

Question: An electron is in an n = 4 state of the hydrogen atom. (a) What is its energy? (b) What properties besides energy are quantized, and what values might be found if these properties were to be measured?

71. In many kinds of integrated circuits. the preferred element of amplification/switching is nor the bipolar transistor discussed in the chapter, but the MOSFET (metal oxide semiconductor field effect transistor). Thecompany diagram shows one in its "normally off" state: Conduction electrons cannot flow from the n-type source, which is analogous to the emitter. "over the bump" in the ptype region to the n-type drain. analogous to the collector. (Annpn arrangement is shown. but just as for the bipolar transistor, a pnp would yield the complementary device.) The important difference is that rather than a direct electrical contact to the p-type region, as in the base of the bipolar, the centre lead, the gate, is a conductor bonded to the p-type region but separated by a thin insulating layer.

(a) Explain how applying a bias to the gate can cause this device to tum on. Should the gate bias voltage be positive or negative (relative to the source)? Why is the control mechanism referred to as "field effect"?

(b) The MOSFET is often said to be a "unipolar" device because valence holes (conduction elections in the pnp device) do not play the important role that they do in the bipolar. Explain. Would you expect a significant current through the gate due to electron-hole recombination in the p-type region? Why or why not?

(c) A low-input-impedance device is one in which there are large oscillations in input current for small oscillations in the input voltage. Correspondingly, a highinput-impedance device has a small input currentfor a large input voltage. Bearing in mind that the voltage across the forward-biased base-emitter diode of a bipolar transistor is always aboutEgape , while the input current is proportional to the output current, would you say that the bipolar transistor has low or high input impedance? What about the MOSFET?

The density of copper is8.9×103kgm3. Its femi energy is 7.0 eV, and it has one conduction electron per atom. At liquid nitrogen temperature (77 K), its resistivity is about 4×10-9Ωm. Estimate how far a conduction electron would travel before colliding and how many copper ions it would pass.

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free