The magnetic field at one place on the earth's surface is 55μTin strength and tilted 60down from horizontal. A 200 turn coil having a diameter of 4.0 cm and a resistance of 2.0Ωis connected to a 1.0μFcapacitor rather than to a current meter. The coil is held in a horizontal plane and the capacitor is discharged. Then the coil is quickly rotated 180so that the side that had been facing up is now facing down. Afterward, what is the voltage across the capacitor?

Short Answer

Expert verified

The voltage across the capacitor,ΔVC=12V

Step by step solution

01

Magnetic Field

The flux density is a study of the magnet that runs through the area A coil. The magnetic field is carried out in a systematic way:

Φm=BAcosθ

The diameter of the coil is d = 4 cm. So, the area of the coil is

A=πd22=π4×102m22=1.25×103m2

A magnetic field is angled below the normal by, yielding in an angle at all between the magnetic force and the coil's normal line. At a certain length of time, the coil revolves by and so its angle gets. As an outcome, the magnetic field is varied from side to side, or the flow is modified.dΦm=BAcos30cos210

02

Faraday's and Ohm's Law

From Faradays, the induced is the change of magnetic field in inside coil yet it is given by in the form

ε=NdΦmdt=NBAcos30cos210dt

The induced current using Ohm's law

I=εR

03

Capacitance of the Capacitor

the current is the change of capacitance in inside coil yet it is given by in the form

dqdt=NBAcos30cos210Rdtdq=NBAcos30cos210R

Related to the induced current in the capacitance to the capacitor

ΔVC=dqC=NBAcos30cos210RC

Those values provided by N, B, A, R and CΔVC=NBAcos30cos210RC

=(200)55×106T1.25×103m2cos30cos210(2Ω)1×106F

=12V

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

One possible concern with MRI (see Exercise 28) is turning the magnetic field on or off too quickly. Bodily fluids are conductors, and a changing magnetic field could cause electric currents to flow through the patient. Suppose a typical patient has a maximum cross section area of 0.060m2. What is the smallest time interval in which a 5.0Tmagnetic field can be turned on or off if the induced emfaround the patient's body must be kept to less than 0.10V??

FIGURE shows a 4.0-cm-diameter loop with resistance 0.10around a 2.0-cm-diameter solenoid. The solenoid is 10 cm long, has 100turns, and carries the current shown in the graph. A positive current is cwwhen seen from the left. Find the current in the loop at(a)t=0.5s,(b)t=1.5s,and(c)t=2.5s.

I A 20-cm-long, zero-resistance slide wire moves outward, on zero-resistance rails, at a steady speed of 10m/sin a 0.10Tmagnetic field. (See Figure 30.26.) On the opposite side, a 1.0Ωcarbon resistor completes the circuit by connecting the two rails. The mass of the resistor is 50mg.

a. What is the induced current in the circuit?

b. How much force is needed to pull the wire at this speed?

c. If the wire is pulled for 10s, what is the temperature increase of the carbon? The specific heat of carbon is710J/kgK.

Your camping buddy has an idea for a light to go inside your tent. He happens to have a powerful and heavy horseshoe magnet that he bought at a surplus store. This magnet creates a 0.20Tfield between two pole tips 10cmapart. His idea is to build the hand-cranked generator shown in FIGURE .He thinks you can make enough current to fully light a 1.0lightbulb rated at 4.0W. That’s not super bright, but it should be plenty of light for routine activities in the tent.

a. Find an expression for the induced current as a function of time if you turn the crank at frequency f. Assume that the semicircle is at its highest point at t=0s.

b. With what frequency will you have to turn the crank for the maximum current to fully light the bulb? Is this feasible?

A 40-turn, 4.0-cm-diameter coil with R=0.40Ω surrounds a 3.0-cm-diameter solenoid. The solenoid is 20 cm long and has 200 turns. The

60 Hzcurrent through the solenoid is I = I0sin(2πft). What is I0 if the maximum induced current in the coil is 0.20A??

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free