Chapter 18

Determine the ratio of the heat flow into a six-pack of aluminum soda cans to the heat flow into a 2.00 - \(\mathrm{L}\) plastic bottle of soda when both are taken out of the same refrigerator, that is, have the same initial temperature difference with the air in the room. Assume that each soda can has a diameter of \(6.00 \mathrm{~cm}\), a height of \(12.0 \mathrm{~cm}\), and a thickness of \(0.100 \mathrm{~cm}\). Use \(205 \mathrm{~W} /(\mathrm{m} \mathrm{K})\) as the thermal conductivity of aluminum. Assume that the 2.00 - \(\mathrm{L}\) bottle of soda has a diameter of \(10.0 \mathrm{~cm}\), a height of \(25.0 \mathrm{~cm}\), and a thickness of \(0.100 \mathrm{~cm} .\) Use \(0.100 \mathrm{~W} /(\mathrm{mK})\) as the thermal conductivity of plastic.

The \(R\) factor for housing insulation gives the thermal resistance in units of \(\mathrm{ft}^{2}{ }^{\circ} \mathrm{F} \mathrm{h} / \mathrm{BTU}\). A good wall for harsh climates, corresponding to about 10.0 in of fiberglass, has \(R=40.0 \mathrm{ft}^{2}{ }^{\circ} \mathrm{F} \mathrm{h} / \mathrm{BTU}\) a) Determine the thermal resistance in SI units. b) Find the heat flow per square meter through a wall that has insulation with an \(R\) factor of 40.0 , with an outside temperature of \(-22.0^{\circ} \mathrm{C}\) and an inside temperature of \(23.0^{\circ} \mathrm{C}\)

A thermal window consists of two panes of glass separated by an air gap. Each pane of glass is \(3.00 \mathrm{~mm}\) thick, and the air gap is \(1.00 \mathrm{~cm}\) thick. Window glass has a thermal conductivity of \(1.00 \mathrm{~W} /(\mathrm{m} \mathrm{K})\), and air has a thermal conductivity of \(0.0260 \mathrm{~W} /(\mathrm{m} \mathrm{K})\). Suppose a thermal window separates a room at temperature \(20.00{ }^{\circ} \mathrm{C}\) from the outside at \(0.00^{\circ} \mathrm{C}\). a) What is the temperature at each of the four air-glass interfaces? b) At what rate is heat lost from the room, per square meter of window? c) Suppose the window had no air gap but consisted of a single layer of glass \(6.00 \mathrm{~mm}\) thick. What would the rate of heat loss per square meter be then, under the same temperature conditions? d) Heat conduction through the thermal window could be reduced essentially to zero by evacuating the space between the glass panes. Why is this not done?