(a) A sound source producing 1.00-kHz waves moves toward a stationary listener at one-half the speed of sound. What frequency will the listener hear? (b) Suppose instead that the source is stationary and the listener moves toward the source at one-half the speed of sound. What frequency does the listener hear? How does your answer compare to that in part (a)? Explain on physical grounds why the two answers differ.

Short Answer

Expert verified

(a) when the source moves towards the listener the frequency heard by him would be 2000Hz

(b) when the listener moves towards the source the frequency heard by him would be 1500Hz.

Step by step solution

01

Dopplers equation

fL=v+vLv+vsfswhere fLis the observer frequency of sound, v is the speed of sound waves,VSis observer velocity, localid="1664336719942" VLis source velocity and fsis actual frequency of sound waves.

02

Calculation

fs=1000Hz, The positive direction is from the listener to the source v=344m/s.

(a)

v=344m/s/2=-172m/svL=0m/s

Apply in doppler’s equation,

fL=v+vLv+vsfs=344m/s344m/s-172m/s1000Hz=2000Hz

Hence, when the source moves towards the listener the frequency heard by him would be 2000Hz.

(b) vs=0,vL=172m/s

Apply in doppler’s equation,

fL=v+vLv+vsfs=344m/s+172m/s344m/s1000Hz=1500Hz

Hence, when the listener moves towards the source the frequency heard by him would be 1500Hz.

The answer in (b) is much less than the answer in (a). It is the velocity of the source and listener relative to the air that determines the effect, not the relative velocity of the source and listener relative to each other.

Unlock Step-by-Step Solutions & Ace Your Exams!

  • Full Textbook Solutions

    Get detailed explanations and key concepts

  • Unlimited Al creation

    Al flashcards, explanations, exams and more...

  • Ads-free access

    To over 500 millions flashcards

  • Money-back guarantee

    We refund you if you fail your exam.

Over 30 million students worldwide already upgrade their learning with Vaia!

One App. One Place for Learning.

All the tools & learning materials you need for study success - in one app.

Get started for free

Most popular questions from this chapter

After a beam passes through 10cm of tissue, what is the beam’s intensity as a fraction of its initial intensity from the transducer?

(a)1×10-11; (b)0.001; (c)0.01; (d) 0.1

A heavy rope 6.00 m long and weighing 29.4 N is attached at one end to a ceiling and hangs vertically. A 0.500-kg mass is suspended from the lower end of the rope. What is the speed of transverse waves on the rope at the (a) bottom of the rope, (b) middle of the rope, and (c) top of the rope? (d) Is the tension in the middle of the rope the average of the tensions at the top and bottom of the rope? Is the wave speed at the middle of the rope the average of the wave speeds at the top and bottom? Explain.

15.4. BIO Ultrasound Imaging. Sound having frequencies above the range of human hearing (about 20,000 Hz) is called ultrasound. Waves above this frequency can be used to penetrate the body and to produce images by reflecting from surfaces. In a typical ultrasound scan, the waves travel through body tissue with a speed of 1500 m/s . For a good, detailed image, the wavelength should be no more than 1.0 mm. What frequency sound is required for a good scan?

A large church has part of the organ in the front of the church and part in the back. A person walking rapidly down the aisle while both segments are playing at once reports that the two segments sound out of tune. Why?

25 A jet airplane is flying at a constant altitude at a steady speed vs greater than the speed of sound. Describe what observers at points A, B, and C hear at the instant shown in the figure, the shock wave has just reached point B. Explain.

See all solutions

Recommended explanations on Physics Textbooks

View all explanations

What do you think about this solution?

We value your feedback to improve our textbook solutions.

Study anywhere. Anytime. Across all devices.

Sign-up for free